12
3. Unscrew the cable clamp(s), and remove the hardware
that holds the blower and L-bracket (previous graphic).
4. Detach the blower and plate, and place them nearby.
Orientating the Blower/Vent L-Brackets
1. Unscrew, and remove the L-bracket that is in the default
top-venting orientation.
2. Turn and align the L-bracket so the hole is in back of the
hood, allowing a rear-venting configuration.
Installation Instructions
Rotating the Blower(s) for Rear
Exhaust, cont.
The images in this section were chosen to illustrate the
intended information and may not exactly represent the
hood being installed.
Disassembling Parts
1. Unhook and remove the grease channel.
2. (Taking care not to scratch the hood) Place the hood as-
sembly on a large, flat surface.
3. Remove the duct collar from the hood top. (Save the
collar and screws.)
Removing the Blower(s)
1. Carefully set the hood on its
back to access the bottom.
2. Find the end of the cable assembly plugged into the
bottom left of the blower
,
then
s
queeze and unplug the
connector. (To avoid damaging the cable assembly con-
tacts and wires,
always
pull by the connector.)
Duct Collar
Back of Hood
Grease Channel
L-Bracket
plate
blower
Back of
Hood
Default Orientation:
Top Vent Open
Rear Vent Closed
Top of
Hood
Blower/Vent
L-Bracket
Back of
Hood
Top of
Hood
Rotated Blower
Orientation:
Top Vent Closed
Rear Vent Open
Blower/Vent
L-Bracket
