Fasten the backguard and the stainless steel trim piece in
place with the five (5) existing chrome plated screws.
Secure the rear of the backguard to the back of the range
with the eight (8) existing hex screws.
On the 24 inch backguard: Secure the “C” channels on the
24 inch backguard to the brackets mounted on the range
chassis using eight (8) hex screws from the kit. Insert the
screws through the holes in the back side of the backguard.
5.
6.
7.
Backguard
Backguard Installation
Chrome Plated
Screw, 5 Places
Hex Screw,
8 Places
Installation Instructions
Removing the Oven Door
WARNING
Do not attempt to disengage the hinge catches with the
door removed from the oven. The hinge springs could
release causing personal injury.
Do not lift or carry the oven door by the door handle.
•
•
NOTE:
When installing a backguard, always install it before
sliding the range into place. See page 8.
To make the range easier to move, remove the door(s) to reduce
weight.
Open the door to its fully opened position.
Rotate the catch over the retaining arm on each hinge.
Lift the oven door to about a 15° angle from the vertical
position.
Hold the door with both hands just below the handle and pull
it away from the oven while continuing to lift.
1.
2.
3.
4.
Door Gripping Points
Retaining Arm
Catch
Releasing the Door Hinges
Installing a Backguard (Continued)
Hex Screw,
8 Places
Securing the Support Brackets on 24 inch Backguard
