7
Installation Instructions
Backguard Kit Installation
See the inside cover for available part numbers and
compatibility.
If installing a backguard other than the standard size,
install it before pushing the range into place. Install the kit
according to the accompanying installation instructions. A
T-20 Torx driver is required.
Self-Rimming Trim Installation
The trim kit is for use with model ER30GI with a self-
rimming cutout only. Install the trim pieces before pushing
the range into place. A T-20 Torx driver is required.
Locate the three (3) trim pieces, the two (2) support
1.
brackets and the eleven (11) #8 x 1/4 Torx screws
included with the range.
Remove and discard the five (5) screws that hold the
2.
backguard in place. Slide the backguard up to remove.
Remove and discard the screws (4 each) that hold the
3.
existing left and right trim pieces in place.
Slide the existing left and right trim pieces up and off
4.
the range.
Slide the provided left and right trim pieces onto the
5.
range. The overhang on each piece goes toward the
back.
Fasten the new trim pieces in place using the provided
6.
#8 x 1/4 Torx screws (2 each side).
IMPORTANT:
To
ensure proper fit of the range in the cutout, do not use
the screws removed from the range in step 4. Use only
the provided #8 x 1/4” Torx screws.
Reattach the backguard using three (3) of the #8 x 1/4”
7.
Torx screws.
Overhang
