3
Important Safety Instructions
Installation Specifications
Product Dimensions
For your safety, do not use the oven to cook without the convection filter installed. When the filter is not installed,
•
the spinning fan blades at the back of the oven are exposed.
The cooktop should never be operated without the knobs and trim rings in place.
•
Non-stick coatings, when heated, can be harmful to birds. Remove birds to a separate, well-ventilated room during
•
cooking.
Always ensure that the light fixture lens cover is in place when using the oven. The lens cover protects the light bulb
•
from breakage caused by high oven temperatures or mechanical shock.
IMPORTANT - This appliance is equipped with a three-prong grounding plug
for your protection against possible electric shock hazards. Plug it only into a
dedicated, grounded three-prong electrical outlet. It is the responsibility of the
customer to make sure the proper type of outlet is installed. Do not under any
circumstances:
Cut or remove the third (ground) prong from the power cord.
•
Use an adapter plug.
•
Use an extension cord.
•
Use a power cord that is frayed or damaged.
•
Connect to an electrical outlet with a ground fault interrupter (GFI).
•
WARNING
1 1/8” (29mm)
1 9/16”
(40mm)
2” (51mm)
3” (76mm)
Front of open door
Front of handle
Front edge of bullnose
Front panel
Rear of front panel
Backguard thickness
26 1/8” (664mm)
27 1/16” (687mm)
28 9/16” (725mm)
24” (610mm)
3” (76mm)
Backguard***
ER30G:
Full stainless
steel side panels
ER30GI:
Partial stainless
steel side panel
Grates extend
1” above trim
6” (152mm)
Backguard*
1 3/4” (44mm) Backguard**
***
**
*
Optional on both models,
NOT
compatible with self-rimming installations
Standard on model ER30G
Optional on model ER30GI,
NOT
compatible with self-rimming installations
Standard on model ER30GI
Optional on model ER30G
Product width:
29 7/8” (759mm)
ER30G is designed for freestanding install-
ations. ER30GI is designed for installation
in a recessed cabinet or island. ER30G is
NOT
equipped for self-rimming installation.
NOTE:
Neither model is
compatible with a raised vent.
35”
(889mm)
to
37 1/8”
(943mm)
9” (229mm)
Backguard***
45 9/16” (1157mm)
All tolerances: ±1/16” (±1.6mm), unless otherwise stated
Overall Dimensions
