Dacor Epicure EH3612, Installation Instructions Manual

Page: 19 / 48

17
Find the temporary mounting bracket in the shipping 3.
box. Put the bracket against the wall and line up the
center hole with the intersection of the bracket center
lines on the wall. Make sure the anchors and/or screws
used are strong enough to support the hood. Make
sure drywall installations are properly reinforced.
Mark the two mounting hole positions through the holes 4.
in the bracket. Drill the pilot holes for the screws or
anchors and attach the brackets securely to the wall.
Installation Instructions
12” high models with rear exhaust:
Center the transition over the duct collars while resting the
unmodified edge on the top of the hood. Fasten in place
using sheet metal screws (not included). Seal the base of
of the transition with duct tape.
Mounting Bracket Installation
Draw the horizontal center line for the temporary 1.
mounting brackets on the wall. The center line for the
brackets is 2 1/8” (54 cm) below where the top of the
hood will be located. The horizontal line marks the cen-
ter line of the mounting screws that hold the temporary
mounting brackets in place.
iMportAnt: Installing the
brackets lower or higher than the center line shown will
cause alignment problems during final installation.
Draw the two (2) vertical center lines for the brackets 2.
on the wall. They are located on both sides of the hood
center line drawn on the wall before making the duct
cut-out. The distance from the center line depends on
the model. See the chart below.
teMporArY BrAcket center line distAnce
Models f
EH3012, EH3018, MH3012, MH3018 12 3/8” (31.4 cm)
EH3612, EH3618, MH3612, MH3618 15 3/8” (39.1 cm)
EH4212, EH4218 18 3/8” (46.7 cm)
EH4812, EH4818, MH4812, MH4818 21 3/8” (54.3 cm)
EH5418 24 3/8” (61.9 cm)
2 1/8”
Bracket
location Bracket
location
Hood
location
F F
Reinforced
drywall