Dacor EOG52, Installation Instructions Manual

Page: 7 / 16

5
i
nsTallaTion
s
peCifiCaTions
Gas and Electrical Supply
Requirements
WARNING
Electrical grounding instructions:
This outdoor cooking gas appliance is equipped with
a three-prong grounding plug for your protection
against shock hazard and should be plugged into a
properly grounded three-prong receptacle. Do not
cut or remove the grounding prong from the plug.
NOTES:
1. If the gas or electric service provided does not
meet the product specifications, do not proceed
with the installation.
2. The grounding plug must not, under any
circumstances, be cut or removed.
3. Check your local codes for proper method
of installation. In absence of local code, this
appliance should be installed in accordance with
the National Fuel Gas Code ANSI Z223.1. Or CAN/
CGA-B149.1, Natural Gas Installation Code or
CAN/CGA-B149.2, Propane Installation Code.
4. Be certain that the appliance being installed is
correct for the gas service being provided.
5. This appliance must be installed by a licensed
plumber or gas fitter when installed within the
Commonwealth of Massachusetts.
Electrical Supply Requirements
Electrical and Gas Supply Requirements
Table 1
Model No.
Electrical circuit
required
Total connected
load Gas type
Manifold
Pressure
Min. Gas
Supply
Pressure
EOG303
120VAC, 60HZ, 15A 2.9 Amps (0.35kW)
Natural 4” Water
Column
7” Water
Column
EOG303LP Liquid Propane 11” Water
Column
12” Water
Column
EOG36 Natural 4” Water
Column
7” Water
Column
EOG36LP Liquid Propane 11” Water
Column
12” Water
Column
EOG52 Natural 4” Water
Column
7” Water
Column
EOG52LP Liquid Propane 11” Water
Column
12” Water
Column
EOSB162 Natural 4” Water
Column
7” Water
Column
EOSB162LP Liquid Propane 11” Water
Column
12” Water
Column
The EOG outdoor grills are factory-equipped with a three-prong,
grounding plug.
Correct voltage, frequency and amperage must be supplied to the
appliance from an isolated, grounded circuit which is protected by
a properly sized circuit breaker or time-delay fuse. The required
voltage, frequency, and amperage ratings are listed on the
product data plate and are also shown in Table 1, see below.
These outdoor grills must be connected to a power source
with copper wire only. The use of aluminum wire may result in
unsatisfactory connections.
It is the owner’s responsibility to ensure that the electrical
connection to this appliance is installed by a qualified electrician.
The electrical installation, including minimum supply wire size
and grounding, must be done in accordance with National
Electric Code ANSI/NPFA 70, (or the latest revision) or
Canadian Electrical Code CAN/CGA C22.1, and local codes and
ordinances.
Total connected loads noted above include the ignition system,
interior lights, and rotisserie motor. Rotisserie motor should be
plugged into the same grounded outlet power source on the same
line as the grill.
Install 120VAC, 15 Amp duplex outlet in an accessible location
under the grill inside the base enclosure. Refer to Base Enclosure
planning cutout dimensions for recommended utilities locations.
NOTE:
Supply access for the rotisserie power or an alternate
120VAC duplex outlet location.