Dacor EOG303, Installation Instructions Manual, Page: 7 / 16

Page 5
STEP 2
Planning Installation - Cart
NOTE:
Dacor offers a protective grill or grill/cart cover. For more information concerning these covers
contact your dacor appliance dealer.
Assembly:
1. Remove the cart from the shipping carton and pallet.
2. Set the cart in an open location and lock the wheel on the cart to minimize potential movement. Remove the right side roll
out tank drawer.
3. Loosen the two fasteners, located in the front right corner behind the horizontal support, temporarily creating a 1/2” gap
between the support rail and right side panel.
4. Remove the EOG from its shipping carton and pallet. Remember to remove the individual components box to lighten the
appliance.
5. Slide the EOG into the cart making
sure that it is all the way back in the
opening as far as possible. At this
point the mounting holes under the
bottom of the EOG should align with
the holes in the cart supports.
6. Tighten the two fasteners that were
loosened in step 3 before securing the
EOG to the cart.
7. Prepare to secure the EOG to the cart
by removing the left drawer. Once
this is out of your way locate the two
assembly bolts which are inside the
EOG parts package.
8. Install the bolts, then return the left
side drawer to its location.
9. Before installing the right side roll out
tank drawer, Install the regulator and
hose on the grill drawer for final gas
connection.
10. Proceed to steps 4 and 5 in the EOG
installation instructions for the appropriate gas and
electrical connections and step 6 to verify proper
operation.
11. Install the right side slide out tank shelf.
12. Five gallon LP tanks are the largest recommended tank for installation in the rollout tank drawer.
Lift up work
Surface
Fixed
wheels
Loosen
Fasteners
1/2" Gap before install
Roll out storage
Drawers (2)
Roll out
LP tank
drawer
Gas and
Electrical
Locking
wheel
Lift up work
Surface
IMPORTANT:
1. Excessive weight warning - Both the cart and the grill are extremely heavy and this installation
assembly process should be accomplished by a minimum of two people.
2. Sheet metal edges can be dangerous in heavy lifting situations, please wear gloves during
assembly.
3. To lighten the grill before assembly, remove individual components box packed inside the grill.
4. Remove the cart from the shipping pallet before installation assembly.
NOTES:
1. The Dacor cart ships assembled ready for the EOG Outdoor Grill installation assembly.
2. All gas and electrical connections should be made after the grill is installed and bolted to the
cart.
3. Your cart is prepared for either natural gas or liquid propane gas connections. However, it is
important to verify that your EOG was ordered correctly. If you will be utilizing LP gas, your
EOG grill must indicate LP in the serial tag identification. Do not proceed with assembly if the
EOG model is not correct. Field conversion from one gas type to another is not recommended
by Dacor.
Shown: OGC36 and EOG36
Length: 41 3/8” (1051mm), Height: 36” (914mm), Width: 26 1/4” (667mm)
Not Shown: OGC52 and EOG52
Length: 57” (1448mm), Height: 36” (914mm), Width: 26 1/4” (667mm)