5
9. Replace the top hinge cover using
the existing Phillips screw.
8. On 3 door (french door) models,
reconnect the wiring plug located
on top of the left top hinge.
r
einsTalling
The
D
oor
(
s
)
After the moving the refrigerator to the location where it will be
used, reinstall the door(s) and freezer drawer front.
1. Replace the rollers.
2. Slide the screws on the
back of the drawer front
into the slots in the drawer
brackets on both sides.
You may need to move
the bottom of the bracket
around slightly to get the
slot to line up with the
screw.
3. Tighten the four front panel
screws completely. Do not
over-tighten.
i
nsTallaTion
i
nsTruCTions
3. Remove the top hinge cover from
the refrigerator door by removing
the Phillips screw. Retain the
screw and cover for later use.
Hinge style may vary.
4. Unscrew the 5/16” hex head
screws from the top hinge.
Remove the hinge and retain it
and all screws for later use.
8. Pull the freezer drawer
completely open.
9. Loosen the four (4)
screws attaching the
drawer brackets to the
drawer front as shown.
NOTE:
Loosen the
screws only three to four
turns. Do not remove the
screws from the drawer
front.
5. On 3 door (french door) models,
disconnect the wiring plug located
on top of the left top hinge by
wedging a flat-blade screwdriver
between the two sections.
6. Lift the refrigerator door(s) from
the center hinge pin.
7. Remove the Phillips screws that
hold the center hinge in place.
Remove the hinge and retain it
and all screws for later use.
4. Install the top hinge loosely using the existing 5/16” hex head
screws.
5. Install the center hinge using the existing Phillips screws.
6. Place the hinge side of the refrigerator
door on the center hinge pin.
7. While holding the refrigerator door
upright, tighten down the top hinge
with a 5/16” hex head driver.
10. Lift the drawer front
upward and off the
screws.
Hinge cover
Top hinge
Center hinge
Top hinge
Hinge pin
Wiring plug
Center
hinge
Wiring plug
Hinge cover
11. Unscrew the hex head
screws from the rollers
and remove.
