7
Replacing the Filter
Air quality is an important part of preserving and maturing good
wine. To maintain good air quality, your Dacor wine cooler or
beverage center is equipped with an activated charcoal filter. It is
located on the rear wall.
Dacor recommends that you replace the filter at least once a
year. Filters (Dacor PN 101844) can be obtained from your Dacor
dealer, parts distributor or at www.everythingdacor.com.
To remove the old filter:
Disconnect the power cord from the electrical outlet or turn off
1.
power at the circuit breaker or fuse box.
Hold the filter by the handle in the center.
2.
Turn it 90° to the left or right. Pull it out.
3.
To install the new filter:
Insert it with the handle in the vertical position.
1.
Turn it 90° to the left or right until it clicks into place.
2.
Reconnect the power.
3.
Care and Cleaning
WARNING
To avoid possible injury due to electric shock, disconnect
•
the power cord or turn off power at the circuit breaker or
fuse box before cleaning the appliance.
Clean only the parts of the appliance listed in this manual.
•
Clean them only in the manner specified.
Do not use a steam cleaner to clean this
•
appliance. Steam
could penetrate the electrical components and cause a
short circuit.
Do not allow water or cleaning fluids to penetrate into the
•
electrical components or ventilation grill.
CAUTION
To avoid damage to your appliance’s surfaces and accessories
during cleaning:
Use only the types of cleaning solutions specified in this
•
manual.
Do not use abrasives such as steel wool, scouring pads,
•
rough sponges or scrub brushes.
Defrosting
The compartment of your appliance defrosts automatically. Water
may form on the rear wall as part of the defrost process. It drains
into a reservoir at the back of the appliance and is heated so that
it evaporates.
Cleaning the Surfaces
Stainless Steel Surfaces
CAUTION
Always wipe stainless steel (silver colored) surfaces with the
grain.
Clean stainless steel surfaces with a mild solution of detergent
•
and warm water. Rinse and dry with a soft, lint-free cloth.
You may also use Dacor Stainless Steel Cleaner
•
(Dacor PN A302) on the stainless steel surfaces. Use it
according to the directions on the package.
Stainless steel that is exposed to chlorine gas and moisture
•
may have some discoloration. This discoloration is normal. If
your unit is used in this type of environment, clean and polish
your stainless steel more often.
If the surface discolors or rust appears, clean it quickly with a
•
non-abrasive cloth and protect it.
Glass Surfaces
To remove finger prints on glass surfaces, use a mild glass
•
cleaner with a soft damp rag.
Other Surfaces
Clean
•
all other surfaces with a soft damp rag. You may soak the
rag with a mild detergent solution.
1) Turn handle 90°
2) Pull out
