11
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
3. Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least 1” (2.5 cm) of the top
soffit.
NOTE
: If an anti-tip board has been used, adjust the leveling
legs until the top of the refrigerator is within ¼” (6.4 mm) of
the bottom of the anti-tip board as shown. Do not crush the
compressor cover.
IMPORTANT
: Adjust in small increments to keep from
damaging the cabinet trim and causing problems with the
door alignment or top grille fit. To avoid damage to the cabinet
or leveling legs, do not apply more than 50 inch-pounds (5.7
Nm) of torque to the leveling bolts. The leveling legs can be
extended to a maximum of 1¼” (3.2 cm) below the rollers.
Level and Align Refrigerator
IMPORTANT
: All four leveling legs must contact the floor to
support and stabilize the full weight of the refrigerator. The rollers
are for moving the refrigerator and not for permanent support.
After moving the refrigerator to its final location:
1. Use a
5
⁄
16
” socket driver to turn the leveling bolts clockwise to
extend the legs to the floor as shown. The rollers should be off
the floor.
2. Adjust the leveling legs to level and align the refrigerator from
left to right and front to back so that the refrigerator is level
and aligned with the cabinetry. The cabinetry surface must be
plumb for the ideal fit of the refrigerator side trim.
Installation Instructions
A. Rear leveling bolt
B. Front leveling bolt
A
B
A
B
A. Center board 1/4” (6.4 mm) max. above refrigerator
B. Two 2” x 4” x 32” (5.1 cm x 10.2 cm x 81.3 cm) boards
C. Attach to studs with six #8 x 3” (7.6 cm) screws
D. Compressor cove
r
2” (5.1 cm)
A
B
C
D
Summary of Contents for DYF42BIWS
Page 17: ......
