English
25
Using the rangetop
Ignition
Each knob for surface burner has its
corresponding burner. The location of
corresponding burner is marked next to
the knob.
To light a burner, follow below steps.
1.
Push in the knob and turn it counter clockwise to the Lite position. The igniter for the
burner will Spark repeatedly until it lights. The spark makes a“clicking” sound. The
burner should light within four seconds. The flame should burn evenly around the
perimeter of the burner, except underneath each grate support finger, where the flame
height is reduced by Dacor’s Smart Flame feature. A normal flame is steady and blue
in color. Foreign material in the gas line, especially in new construction, may cause
an orange flame during initial operation. This will disappear with further use. Small
yellow tips on the ends of the flames are normal when using LP gas. If a burner does
not ignite, the igniter continues to spark or if the flame is not spread evenly around
the burner cap, see the
.
2.
Place the cooking utensil on the grate.
3.
Adjust the flame to the level necessary to perform the desired cooking process.
NOTE
When a burner knob is set to LO, the igniter may continue to spark if the burner is cold.
The burner will stop sparking when warm. To reduce cold burner sparking, set the knob
to HIGH for about 60 seconds, then right the flame to cook. The igniter will also spark
automatically if the flame is distorted by a draft or by the household ventilation system.
Eliminate any drafts or reduce the ventilation blower speed to reduce this type of
problem.
