PLANNING
GUIDE
10.2
Specifications subject to change without notice.
Phone: (800) 793-0093
www.Dacor.com
DDWF24S
24” Wide Built-In Dishwasher
DIShWAShEr CUtoUt - FroNt VIEW
Cutout tolerances: +1/16” (+1.6 mm), -0
Document # PG10-004
Revised 02/03/11 Page 2/3
Location Specifications
■
Install in a location with convenient access, close to the kitchen sink
for easy water supply and drain connection. All minimum product
dimensions must be met or exceeded. Dimensions shown on this
page provide the required clearances.
■
The cabinet must enclose the dishwasher on top, back and sides.
■
Plan the installation so that the appliance can be removed easily if
service is required. The electrical outlet/junction box, water supply
valve and drain connection must be installed to the right or left of the
unit and accessible when dishwasher is installed.
■
If dishwasher is installed in a corner, there must be a minimum
clearance of 2” (5.1 cm) from the side wall so the door can open. See
diagram.
■
Floor must be solid and level. All cutout surfaces must be at right
angles. Surrounding cabinet must have sufficient material for
attachment of the anti-tip brackets (see installation instructions).
■
The power cable, the drain hose and water supply line must enter
through one or both of the access hole locations shown below. The
access hole(s) must have no sharp edges that could damage the
power cord, water supply line and drain hose passing through them.
* If the height of the existing cutout is too low:
■
Check to see if the cabinet face can be trimmed at the top. In many
cases, when a non-standard size dishwasher has been installed
previously, there is enough room inside the cabinet once the cabinet
face is modified.
■
The dishwasher can be shortened 1/4” (6.0 mm) by not installing the
plastic feet provided with the unit. Extra care must be taken if the feet
are not installed. Dacor is not responsible for floor damage during
installation.
■
The dishwasher can be shortened 1/4” (6.0 mm) by removing the trim
pieces that surround the wash compartment opening.
nOTE:
Doing
so will create a gap of 1/4” (6.0 mm) on the right and left side of the
door.
2” (5.1 cm) min.
clearance
24” (61.0 cm)
23 5/8”
(60.0 cm)
Power cable/water
supply access hole(s)
1 ½” x 1 ½” max.
(3.8 cm x 3.8 cm)
Drain line access
hole 2” x 2”
(5.1 cm x 5.1 cm)
34 1/2“
(87.6 cm)
to
36 1/2”
(92.7 cm)
A
*
See
Drain
Specifications
