3
•
It is recommended that your local E.C.A. (Electrical Contractors Association) is contacted in order
to obtain the legal wiring regulations pertaining to the area.
•
Electrical Shock may occur while installing this equipment.
•
Injury or death by electrocution may lead to law suits against the installer/homeowner.
•
If you intend to run 220V/AC directly from the Mains supply (house supply) to the transformer, the
wiring should be done by a qualified/registered electrician. This is a legal requirement and failure
to do so may lead to non compliance of property or law suits against the property owner in the
event of an accident.
•
It is a legal requirement to run all cabling in conduit. The power supply must be run in a separate
conduit to ANY other cables.
•
Mains supply may only be run in a guarded cable. Under no circumstances may 220V/AC be run
using Communication, Ripcord Cables or Cabtyre.
•
D.A.C.E will not be held liable for any accident / incident resulting in damage, injury or death
ensuing from the installation of the automatic gate motor.
•
Although the DuraSlide has built-in collision sensing, substantial damage may occur. For this
reason safety beams should be used on all installations.
•
Do not allow children to play near or with any gate, gate motor or remote control.
•
It is the responsibility of the installer to ensure that the gate is in good working condition before
automating the gate.
•
Assorted screw drivers – Phillips and flat
•
17mm spanner
•
17mm Socket
•
Tape Measure
•
Spade
•
Pick
•
Spirit Level
•
Drilling Machine
•
Steel Drill Bits
•
Masonry Drill Bits
•
Hammer
•
Multi Meter
•
Side Cutters
•
Hacksaw
LEGAL REQUIREMENTS AND WARNINGS FOR INSTALLING THIS EQUIPMENT
RECOMMENDED TOOLS
