Dabi Atlante EAGLE 3D, User Manual, Page: 11 / 108

10
3.5. ADDITIONAL PROCEDURES PRIOR TO EQUIPMENT USE
Even prior to its first use, the equipment must be cleaned and disinfected; the same
additional procedures must be followed for reuse, as described in Chapter 12.
3.6. WARNINGS AND/OR CAUTION TO BE ADOPTED
3.6.1. WARNINGS AND/OR CAUTION DURING EQUIPMENT INSTALLATION

The equipment must be installed only by service technicians authorized by the
manufacturer.

Place the equipment on a site where it will not be in contact with moisture or
water.

Install the unit on a site where it will not be damaged by pressure, temperature,
moisture, direct sunlight, dust or salts.

The equipment must not be submitted to inclination, excessive vibration or shock
(including during transportation and handling).

This equipment has not been designed for use in facilities where vapors,
flammable anesthetic mixtures in contact with air, oxygen or nitrous oxide can be
detected.

Check the equipment’s voltage when performing electric installation. Failure to
do so may damage the equipment.

The equipment must be properly grounded. Failure to do so may result in
“Safety Hazard”.

Depending on local regulation the X-Ray emission control may require
installation outside the facility where the equipment is placed, and the operator
may need visual contact with the patient through a window with radiological glass
or similar, since the operator must not lose visual contact with the patient.

Mobile and portable RF communication equipment can affect the Eagle 3D
Computerized Tomography Machine.

This equipment must be solely used by health care professionals as it may cause
radio interference or interrupt the operation of nearby equipment. Mitigatory
measures, such as equipment re-orientation or replacement and the facility’s
screening, may be necessary.
3.6.2.WARNING AND/OR CAUTION DURING EQUIPMENT USE

The equipment must be operated only by qualified and trained professionals
(dentists, radiology technicians, hygienists or engineers).

Always observe the display messages, the equipment as a whole and the
patient in order to detect any arising problems early.

In case occasional maintenance is required, use only services provided by
Authorized Service Technicians.

The equipment has been designed to withstand continual and intermittent
operation; therefore, follow the cycles described in these operation
instructions.