ENGLISH
GB
13
Input wiring
Input connected to clean contact
Voltage input
Input
Clean contact between pins
Jumper
Connection
I1
I1-VS
CB - GND
I1 - CB
I2
I2-VS
CB - GND
I2 - CB
I3
I3-VS
CC - GND
I3 - CC
I4
I4-VS
CC - GND
I4 - CC
An input mode is described in Figure 1, just as an example (Connec
-
tion to Input 1)
Table 2: Input wiring
Output contacts:
The connections of the outputs listed below refer to the 9-pole terminal
board (J15), indicated with screen printing O1, O2 and CA.
Table 3 describes the characteristics and limits of the output contacts.
Characteristics of the output contacts
Type of contact
NO (Normally open)
Max. bearable voltage [V]
24
Max. bearable current [A]
5 -> resistive load
2,5 -> inductive load
Max. accepted cable section [mm²]
2,5
An example of connection on the output contacts is shown below in Figure 2.
Table 3: Characteristics of the output contacts
Figure 2: Example of wiring of input I1, input with clean contact
Figure 3: Example of output connection