DAB DCONNECT BOX, Manual, Page: 63 / 148

ENGLISH
61
11.7
Example of Updating Active Driver Plus (SW versions 1.X)
This Update is required to allow Active Driver Plus units with older software to be regularly
recognised by the DConnect Box.
This is a special software update, therefore we recommend that you perform the steps
indicated individually on each Active Driver Plus, keeping the remaining units in any group
switched off during operation.
Note: The update will take about 2-3 minutes for each Active Driver Plus.
Initial Requirements:

Check if the Active Driver Plus has a software version (Sw) 1.X (check the VE parameter or the
technical product label, If the versions are different, please consider only the VE parameter). If the Sw
version is 2.X or above, this procedure is not required.

Manual of the product to be connected.

Special communication cable network available as product accessory.

DConnect Box already updated and powered, see section Updating the DConnect BOX of this
manual.
The connection between Active Driver Plus and the DConnect Box requires the use of the special cable
available as an accessory.
1. Verify that the Active Driver Plus is turned off.
2. Turn on the DConnect and wait 90 secs.
3. Remove the front panel of the Active Driver Plus, remove the closing plug and fix the cable gland of
the connecting cable to the body of the product as shown in Figure 9A (refer to the product manual).
4. Connect and tighten the wires of the connecting cable in the terminal board, ensuring that the
GND
screen (Y) is connected to the central pin of the connector.
5. Connect and tighten the wires at the other end of the cable to the mobile terminal board of the
DConnect Box as in the photo, ensuring that each wire repeats the same position as the other terminal
inserted in the Active Driver Plus. See Figure 9A.
6. Connect to the DConnect Box the special communication cable available as an accessory.
7. Hold down the buttons and turn on the AD plus.
8. The message: “Loader LV” appears on the Active Driver Plus display. Release the buttons and, if
necessary, the product will be updated. A progress bar visually indicates the current level of progress
of the updating task. See Figure 9B.
9. Once the update is successful, the pump will restart automatically.
10. When updating multiple Active Driver Plus units, perform steps 1-10 on each of the other
products.
11. For the connection to the DConnect Box refer to section "11.6 Example of DConnect Box
connection with AD plus".