background image

Printed in U.S.A.

79299  Rev. 5/01

TROUBLESHOOTING

SYMPTOM

4. Door does 

not

close.

Door does 

not

close tightly.

5.

“Down”

limit switch incorrect.

6. Noise.

NOTE: Screen will operate with a low-
pitched hum.

7. Coasting.

8. Roller displaced from mounting

bracket.

9. Fabric hangs crooked.

CAUSE

(a)

Open door limit switch.

(b) Door limit switch is not adjusted

properly.

(a)

“Down”

limit switch out of 

adjustment.

(a)

Squeaking, rubber end plug rubbing
on motor.

(b) Grinding. Foreign object in screen

rubbing on roller or fabric.

(c)

Gear noise.

(a)

Defective brake.

(a)

Pin end slipped out of nylon bearing.

(a)

Screen not installed properly.

(b) Fabric has backed up inside case.

(c)

Fabric is damaged.

SOLUTION

(a)

Replace switch.

(b) Turn adjustment knob counterclock-

wise. Do not over adjust and stall the
motor.

(a)

See installation instructions.

(a)

Center roller in case.

(b) Remove foreign object.

(c)

Replace motor assembly.

(a)

Replace motor assembly.

(a)

Remove pin end mounting. Realign
motor in tube. Reattach pin end.

(a)

Check for level and plumb.

(b) Adjust 

“down” 

limit switch slowly

until roller is exposed and wrinkle
comes out, then readjust for proper
drop.

(c)

Replace fabric.

LIMITED ONE YEAR WARRANTY ON DA-LITE PROJECTION SCREENS

Da-Lite Screen Company, Inc. warrants its screens to the original purchaser only, to be free from defects in materials

and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are prop-
erly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after ship-
ment from the factory.

This warranty does not apply to equipment showing evidence of misuse, abuse, or accidental damage, or which has

been tampered with or repaired by person other than authorized Da-Lite personnel.

Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the

merchandise. Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the
screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not
responsible for damage in shipment. To protect yourself against damage or loss in transit, insure the product and prepay
all transportation expenses.

THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES AS

TO FITNESS FOR USE AND MERCHANTABILITY. Any implied warranties of fitness for use, or merchantability, that may
be mandated by statue or rule of law are limited to the one (1) year warranty period. This warranty gives you specific
legal rights, and you may also have other rights which vary from state-to-state. NO LIABILITY IS ASSUMED FOR
EXPENSES OR DAMAGES RESULTING FROM INTERRUPTION IN OPERATION OF EQUIPMENT, OR FOR INCIDENTAL,
DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE.

In the event that there is a defect in materials or workmanship of a Da-Lite Screen, you may contact our Customer

Service Department at P.O. Box 137, Warsaw, Indiana 46581-0137 (219/267-8101) Toll Free (800/622-3737).

IMPORTANT: 

THIS WARRANTY SHALL NOT BE VALID AND DA-LITE SHALL NOT BE BOUND BY THIS WAR-
RANTY IF THE PRODUCT IS NOT OPERATED IN ACCORDANCE WITH DA-LITE’S WRITTEN
INSTRUCTIONS.

Keep your sales receipt to prove the date of purchase and your original ownership.

Summary of Contents for Tensioned Director Electrol









Reviews: