3
Figure 1
Wall Mounting Instructions
NOTE:
The screen is shipped with two wall brackets. Screens in
widths of 88¾” and below receive (2) 28” wall brackets. Screens
above 88¾” in width receive (2) 44” wall brackets. Use appropriate
mounting hardware for the wall type and to accommodate for
the screen’s hanging weight (Figure 1).
1. Secure the two wall brackets to wall studs at the desired height.
The outside edge of each wall bracket must be no greater than 5”
away from the left and right edges of the frame. You will need at
least 2” clearance above the drilled holes to hang the screen
(Figure 1) .
2. To install the striker plate, take your screens overall height
(including frame) and subtract 1¼”. Using that dimension, measure
down from the top edge of the wall brackets and mark the wall
for a screw hole (Figure 1).
NOTE:
Make sure your mark corresponds with where you intend
the center of your image to be once the screen is fully installed.
3. Secure the striker plate to the wall at the marked locations.
NOTE:
Make sure the screw head is flush to the face of the striker
plate so that the full pull force of the magnet is acheived.
4. With two people, one on either end of the screen, lift the screen
onto the wall. Making sure the wall brackets are securely seated in
the back of the screens frame.
5. Slowly lower the bottom of the screen, making sure the center of
the screen is aligned with the striker plate on the wall.
CAUTION: Pinch Hazard. While lowering the screen, be
careful to keep your fingers clear of the magnet and striker
plate.
Overall Height Less 1¼”
Striker Plate
