SETTING UP YOUR SCREEN
1. Hold screen vertically with tripod just above
floor. With toe, press straight down on toe
release plate. Tripod legs will glide open.
2. Pull out Red Locking Knob at top of bottom
tube.
3. Raise extension tube to first position, and
then swing case to horizontal position.
4. Raise screen surface and pull bail over
hanger. If Keystone Eliminator is to be used,
(1) simply grasp the knurled tip which
protrudes slightly above the hanger; (2) pull
straight up; (3) then lay in a horizontal
position over the hanger, and place the pull
bail on it.
5. Release Red Locking Knob and fabric
tension lock lever on handle.
6. Holding extension tube with one hand and
releasing Red Locking Knob with other, raise
extension tube to desired position.
7. The case position may be changed by
pulling out the Red Locking Knob located
on the handle.
8. For rectangular picture area on screens with
square surfaces, move case to desired
position and lock by pressing down on the
fabric tension lock lever.
9. On models with Super Wonder-Lite surface,
press down on handle until surface is taut.
Lock by pressing down on fabric tension
locking lever.
CLOSING THE SCREEN
1. Return screen case to original central
position on center tube. On models with
Super Wonder-Lite surface, first release
fabric tension lock lever on handle.
2. Hold extension tube firmly. Pull out top Red
Locking Knob and lower extension tube to
bottom position.
3. Unhook screen pull bail and complete re-
rolling fabric into case.
4. If Keystone Eliminator has been used,
simply raise it to a perpendicular position
and push it back into the extension tube.
5. Swing case to vertical position. Note that
fabric locks in.
6. Set tab on hanger in opening of case end
cap. As extension tube locks, the case
also is locked.
7. Place tip of middle finger of right hand in
depression beneath leg bracket. Lift leg
bracket sharply, at the same time applying a
slight lift to entire unit with left hand. Note
that legs are closed and locked, hanger, and
extension tube and case are locked and
surface is locked to provide for safe and
comfortable carrying and storing.
USING SCREEN IN LOWEST POSITION
Follow steps 1 through 3 above.
a. Raise locking lever on left side of handle.
b. Release red knob and lower case.
c. Holding bottom tube, raise extension tube
until it locks into desired position.
Before re-rolling surface into case, examine both
front and back of surface to be sure they are
free of foreign matter. A Da-Lite Screen case
cover is a wise and economical investment.
PROTECT YOUR SCREEN
