4
1. Use the supplied #10 screws to attach six frame
brackets to the back of the frame as shown in
Figure 8.
2. Secure the wall brackets to wall studs at the
desired height. Make sure the brackets are level.
The top of the frame will be 1/8" above the top of
the wall bracket when mounted. You will need at
least 5/8" clearance above the bracket to hang the
screen.
3. To install the lower wall bracket, you must
measure the overall height of the screen frame
and subtract 1/4". This is the dimension from the
top of the upper wall bracket to the bottom of the
lower wall bracket. See Figure 6.
4. For 150", 180", 200", 220" and larger screens with
2-piece side frame rails you will will need to
attach one High Power bracket to each side
frame rail. Use the black #10 screws supplied.
See Figure 8.
5. Unroll the screen on a clean surface. Do not use
newspaper. The viewing side is rolled to the
inside of the roll. Place the frame over the screen
surface, and while lifting the frame with one
hand, snap the screen surface onto the frame
with the other hand while maintaining a steady
pull on the surface.
6. Position the screen with the attached surface
onto the top wall bracket as shown in Figure 7.
Push down at the center of the bottom frame rail
to hook onto the lower wall bracket.
7. If you attached brackets to the side frame rails in
step 4, anchor these to the wall with an
appropriate fastener for your type of wall.
1. Use the supplied #10 screws to attach two frame
brackets and two High Power brackets to the
back of the frame as shown in Figure 9.
2. Secure the large wall bracket to wall studs at the
desired height. Make sure the bracket is level.
The top of the frame will be 1/8" above the top of
the wall bracket when mounted. You will need at
least 5/8" clearance above the bracket to hang the
screen.
3. Unroll the screen on a clean surface. Do not use
newspaper. The viewing side is rolled to the
inside of the roll. Place the frame over the screen
surface, and while lifting the frame with one
hand, snap the screen surface onto the frame
with the other hand while maintaining a steady
pull on the surface.
4. Position the screen with the attached surface
onto the top wall bracket as shown in Figure 7.
Push down at the center of the bottom frame rail
to tension the fabric. Mark the screw holes for
the bottom brackets. Drill holes in wall and attach
the brackets to the wall with screws.
FIGURE 9
FRAME BRACKETS
2-PIECES
#10 SCREWS
8-PIECES
LARGE WALL
BRACKET
1-PIECE
HIGH POWER BRACKET
2-PIECES
METHOD 3 (SCREENS OVER 96" IN VIEWING
WIDTH)
METHOD 4 (HIGH POWER FABRIC)
FIGURE 8
FRAME BRACKETS
6-PIECES
#10 SCREWS
12-PIECES
LARGE WALL
BRACKETS
3-PIECES
HIGH
POWER
BRACKET
FOR
LARGE
SPLIT
FRAMES,
AND 150",
180", 200"
AND 220"
DIAGONAL
SCREENS.
2-PIECES
