background image

2

There are four methods of installation based on the size
of the screen and type of viewing surface. Measure the
width of the viewing area of your screen and refer to the
appropriate method of installation below. The wall
bracket diagram shows the type and quantity of bracket
that is supplied based on the size of the screen.

Method 1: Screens 80" and smaller in viewing width.

Method 2: Screens over 80" up to 96" in viewing width.

Method 3: Screens over 96" in viewing width.

Method 4: Any size screen with High Power viewing
surface.

INSTALLATION

4. Attach the small wall bracket to the wall. Refer to

Figure 4 for proper orientation. Do not tighten the
screws completely. The bracket should slide up and
down easily.

5. Unroll the screen on a clean surface. Do not use

newspaper. The viewing side is rolled to the inside of
the roll. Place the frame over the screen surface, and
while lifting the frame with one hand, snap the
screen surface onto the frame with the other hand
while maintaining a steady pull on the surface.

6. Hang the screen on the brackets by hooking the

bottom of the frame onto the small wall bracket and
lift up until you can hook the top of the frame on the
top bracket. Push down on the frame to seat it on the
brackets. Refer to Figure 4.

OVERALL HEIGHT - 1-3/8"

OVERALL 

HEIGHT

6"

2

LIFT

3

1

W

ALL

1. Use the supplied #10 screws to attach three frame

brackets to the back of the frame as shown in Figure
2.

2. Secure the large wall bracket to wall studs at the

desired height. Make sure the bracket is level. The
top of the frame will be 1/8" above the top of the wall
bracket when mounted. You will need at least 5/8"
clearance above the bracket to hang the screen.

3. To install the small wall bracket, you must measure

the overall height of the screen frame and subtract
1-3/8". Using that dimension, measure down from the
top edge of the large wall bracket and mark the wall
for two screw holes. The holes should be centered
within the frame and 6" apart. Refer to Figure 3.

METHOD 1 (SCREENS 80" AND SMALLER IN
VIEWING WIDTH)

FIGURE 2

FRAME BRACKETS
3-PIECES

#10 SCREWS
6-PIECES

LARGE WALL
BRACKET
1-PIECE

SMALL WALL BRACKET
1-PIECE

METHOD 1 (SCREENS 80" AND SMALLER IN
VIEWING WIDTH)

FIGURE 3

FIGURE 4

Summary of Contents for Da-Snap 79982







Reviews: