D-MAX DSC-300Se5, User Manual

Page: 13 / 45

11
1). DIP SWITCH SETTING
3. DIRECIONS FOR USE
Set the power of the camera
switch-off to control the dip
switch and set switch-on after
using it.
This part is a power switch
Ser the camera numbers in the state of
ADDR. Set communication speed.
Protocol in the state od INIT.
- This part is each address od camera
It is a notice to turn the data signal
on.(in power on, the green led is
turned on
-Terminalation resistor (DIP SW NO1)
~ Turn the last camera on the data line as a
switch to turn on/off the terminal resistor on.
Turn the DIP S/W of some od the farthest
cameras on in the case of the data lines
distributed to several directions.
( The first default is off )
-RS485/422 select (DIP SW NO2)
~ Turn on or off for the suitable data system
between RS485 and RS422
( The first default is RS485 )
- Address/Initial select (DIP SW NO3)
~ Set the DIP SW up in the ADDRESS
( reference the next page )
(The first default is address)
~Set the communication speed and
protocol(Demand for the technical inquiry) up
in the state of the initial
-Internal/External (DIP SWNO5)
~ Use it when selecting Internal and External
(The first default is Internal)