DSN-4000 Series Hardware Reference Guide
29
Appendix B Installing the System in a Rack
This appendix describes how to install the DSN-4000 series array in a rack.
At least two persons are required to safely lift, place, and attach the DSN-
4000 series array system into a rack.
Do not lift or move the DSN-4000 series storage system by the handles,
power supply or the Controller Module. Instead, hold the complete system
itself.
Be sure all switches are OFF before installing the DSN-4000 series storage
system or replacing any components.
To install the DSN-4000 series storage system into a rack:
1.
Select the locations in the rack where you will be installing the rails that will support
the primary array and any expansion arrays (if appropriate). When selecting a location,
note the location of the three mounting holes on the rack’s front vertical supports and
the two mounting holes on the back vertical supports, as shown in the following figure.
These locations will become important when you secure the rails and the array to the
rack.
Figure B-1. Example of Mounting Hole Locations on the Front Rails
2.
Check the fit of the mounting rails in your rack system.
3.
Adjust the length of the mounting rails as needed.
4.
Attach the mounting rail assemblies to the outside of the rack posts, using the attaching
screws from your rack system. Be sure the support is on the bottom facing inward.
5.
Square the rail assemblies in the rack.
6.
Tighten the adjustment screws and the attaching screws.
7.
Place the DSN-4000 series storage system onto the rails.
8.
Secure the DSN-4X00 storage system to the rack through each handle, using the
attaching screws from your rack system.
All manuals and user guides at all-guides.com
