Configuration
D-Link Web Smart Switch User Manual
7
7
1
1
Click
Apply
to implement the changes made.
Access Control List (ACL) allows you to establish criterion to determine whether or not the Switch will
forward packets based on the information contained in each packet's header. This criterion can be specified
on a basis of the MAC address, or IP address.
ACL > ACL Wizard
The ACL Configuration Wizard will aid with the creation of access profiles and ACL Rules. The ACL Wizard
will create the access rule and profile automatically. The maximum profiles are 50 and with 200 Rules in total
for the Switch.
Figure 4.84 – ACL > ACL Wizard
From / To:
The rule can be created to apply to different categories:
Any –
Select this to include any starting category to this rule.
MAC Address –
Select this to enter the source and destination of MAC addresses for this rule.
IPv4 Addresses –
Select this to enter the source and destination of IPv4 addresses for this rule.
Service Type:
Specify the Type of Service to match. The possible values are:
Any
–
Indicates any service type of packets are examined.
Ether type
–
Select Ethernet type and IP, ARP or User Define value for filtering packets.
LLC –
Select the IEEE 802.2 Logic Link Control Layer (LLC) header, including SSAP, DSAP and
Control fields, for filtering packets.
ICMP All
–
Indicates all ICMP packets are examined.
IGMP
–
IGMP packets can be filtered by IGMP message type.
TCP All
–
Indicates all TCP packets are examined.
TCP Source Port
–
- Specify packets from the TCP source port.
TCP Destination Port
–
Matches the packet to the TCP Destination Port.
UDP All
–
Indicates all UDP packets are examined.
UDP Source Port
–
Specify packets from the UDP source port.
UDP Destination Port
–
Matches the packet to the UDP Destination Port.
Action:
Specify the forwarding action for packets matching the ACL rule.
Permit
– Specifies that the packets that match the access profile are forwarded by the Switch.
Deny
– Specifies to drop packets if all conditions are met.
Ports:
Enter a port number or a port range to be configured.
Press
Apply
for the settings to take effect.
