13
Installation is now complete.
Installation Wizard (continued)
IMPORTANT:
A hardware reset of the Internet Camera may be required if the
Installation
Wizard
cannot find the camera. To accomplish this reset, lightly insert a paper
clip (or a similar sized tool) into the reset hole on the back of the camera (see
page 6 for the location of the reset hole). The LED on the front of the camera
will begin blinking orange. When it stops the blinking cycle continue to hold in
the reset button until a second cycle of blinking red and green lights indicates a
second reset cycle has completed. This will take approximately 5-7 seconds.
The opening Installation Wizard screen
will appear and
show a MAC address of
the
DCS-5300
and an IP Address (which
may or may not be correct depending on
what you have your
DCS-5300
connected
to). If you have a DHCP* server on your
network, there will be a valid IP Address
displayed here, indicated by a “Yes”
under the assigned column.
*A DHCP server is a device that supplies
IP Addresses to its clients that are on the
same network.
Click
Finish
.
To access the Installation Wizard
screen, click on the Installation
Wizard Icon on your desktop.
