56
Configuration > Tools > Applications (Continued)
Weekly schedule:
Sunday through Saturday -
Select the weekdays that should perform the
following operations:
Snapshots begin at
-
Snapshots stop at
-
Sets the time to stop the operations.
All the time except for the
above schedule
-
If you do not wish to set a schedule, this box
must be checked.
Using the DCS-3220G with an Internet
browser (continued)
Set the time to start operations. Setting the
begin
time the same as the
stop
time will force the
operations to run continuously.
Event operation:
Delay second(s) before
detecting next event -
Sets the time delay before restarting to check the
trigger condition when the current condition is
triggered.
Take snapshots at
second(s) after event -
After a snapshot is taken because of a trigger,
another snapshot will be taken after the
configured time in seconds.
Trigger condition -
There are 4 conditions related to the digital input
and three windows for motion detection. There
can be multiple selections. Select the appropriate
digital input condition according to the
characteristics of the external device.
High
or
low
indicate external voltage input for level trigger,
while
rising
or
falling
is for edge triggers. There
are three windows shown for the names you
defined for motion detection.
Undefined
will
show instead of the window title if motion
detection is not setup yet. An active, named
motion window must be checked for motion
detection to be possible.
Snapshot Interval -
Interval of time between each sequential
snapshot.
Summary of Contents for SECURICAM Network DCS-3220G
Page 139: ...139 Time Zone Table continued...