29
Using & Configuring the DCS-3220G with a
NAT Router (continued)
Ports that are used by the DCS-3220G
Router Set-Up and Installation
The following steps generally apply to any router that you have on your network.
The D-Link DI-614+ is used as an example to clarify the configuration process.
Configure the initial settings of the DI-614+ by following the steps outlined in the
DI-614+
Quick Installation Guide
.
Access Your Router on Your Web Browser
If you have cable or DSL Internet service, you will most likely have a dynamically
assigned WAN IP Address. ‘Dynamic’ means that your router’s WAN IP address
can change from time to time depending on your ISP. A dynamic WAN IP Address
identifies your router on the public network and allows it to access the Internet.
To find out what your router’s WAN IP Address is, go to the
Status
menu on
your router and locate the WAN information for your router (as shown on the
next page). The WAN IP Address will be listed. This will be the address that you
will need to type in your Web browser to view your camera over the Internet.
These are the port settings
for your camera. If necessary,
these ports can be changed
if they are already in use by
other devices (e.g. in a mul-
tiple camera environment).
Summary of Contents for SECURICAM Network DCS-3220G
Page 139: ...139 Time Zone Table continued...