DXS-3600-32S 10GbE Layer 2/3 Switch Hardware Installation Guide
4
Please refer to the “
LED Indicators
” section in the
Appendix A
for more LED information.
Ports
Ports that can be found on the front panel of this switch are listed in the table below.
Fan1, Fan2, Fan3
This LED will light solid green when the fan is operating normally.
This LED will light solid orange when the switch is booting up or when a diagnostics
test is taking place.
This LED will blink orange when a fan fails.
This LED will be off when the fan is not receiving power.
SD
This LED will light solid green if a Secure Digital (SD) card is plugged in.
This LED will blink green when the Switch is reading or writing data to and from the
SD card.
This LED will be off when no SD card is plugged into the SD port.
This LED will light solid red when an SD card failure has been detected.
Link/Act LEDs
This LED will light solid green when there is a secure connection to a 10Gbps Ether-
net device at any of the ports.
This LED will light solid orange when there is a secure connection to a 1Gbps Ether-
net device at any of the ports.
This LED will blink green when a 10Gbps port is active, or blink orange when a
1Gbps port is active.
This LED will be off when there is no link or activity.
Stacking ID
This 7-segment LED can display numbers from 1 to 12 and the following letters H, h,
E, and G. The stacking ID (1 to 12) can be assigned manually by the user or auto-
matically by the system.
The letter ‘
H
’ will be displayed if this switch is the
master switch
in the stack.
The letter ‘
h
’ will be displayed if this switch is the
backup master switch
in the
stack.
The letter ‘
E
’ will be displayed if there was an error in the system’s self-test.
The letter ‘
G
’ will be displayed when the
Safeguard
engine entered the
exhausted
mode
.
Port
Description
SD Card Slot
This port can be used to insert an external SD memory card. The maximum capacity
SD card that can be inserted into this port is 32Gb.
Management port (MGMT)
This port is a 10/100/1000Mbps Ethernet port with an RJ-45 connection. This Out-
Of-Band management port that can be used to configure this switch without being
connected to the network.
Console port
This port is an RJ-45 connection port that can be used to connect to the Command
Line Interface (CLI) of this switch for configuration, management and monitoring.
This port uses a special console cable (included with the packing) with a DB9 inter-
face to connect the Switch to a PC’s COM port.
10 Gigabit ports
This switch is equipped with 24 SFP/SPF+/WDM ports. These ports can operate at
10Gbps speeds and support a vast collection of SFP/SFP+/WDM transceivers.
Expansion Module Slot
This slot can be equips with 5 kinds of modules.
•
DEM-3600-EM-4XT
(Four 10GBASE-T Copper ports)
•
DEM-3600-EM-8T
(Eight 1000BASE-T Copper ports)
•
DEM-3600-EM-4QXS
(Four 40Gbps QSFP+ transceiver slots)
•
DEM-3600-EM-8XS
(Eight 10Gbps SFP+ transceiver slots)
•
DEM-3600-EM-Stack
(Two 120Gbps CXP Stacking ports)
LED
Description
