D-Link DWS-1008 User Manual
0
Boot:
Filename
Size
Created
*boot0:bload
746 KB
May 09 2004, 19:02:16
*boot0:mx030000.020
8182 KB
May 09 2004, 18:58:16
boot1:mx030000.020
8197 KB
May 21 2004, 18:01:02
Boot0: Total: 8928 Kbytes used, 3312 Kbytes free
Boot1: Total: 8197 Kbytes used, 4060 Kbytes free
===============================================================
temporary files:
Filename Size Created
Total: 0 bytes used, 93537 Kbytes free
Removing a Subdirectory
To remove a subdirectory from nonvolatile storage, use the following command:
rmdir [
subdirname
]
To remove subdirectory corp2, type the following example:
DWS-1008#
rmdir corp2
success: change accepted.
Managing Configuration Files
A configuration file contains CLI commands that set up the switch. The switch loads a designated
configuration file immediately after loading the system software when the software is rebooted. You also
can load a configuration file while the switch is running to change the switch’s configuration.
When you enter CLI commands to make configuration changes, these changes are immediately added
to the device’s running configuration but are not saved to the configuration file.
This section describes how to display the running configuration and the configuration file, and how to
save and load configuration changes. A procedure is also provided for resetting the switch to its factory
default configuration.
Displaying the Running Configuration
To display the configuration running on the switch, use the following command:
show config [area
area
] [all]
The
area
area
parameter limits the display to a specific configuration area.
The
all parameter includes all commands that are set at their default values. Without the all parameter,
the show config command lists only those configuration commands that set a parameter to a value
other than the default.
Summary of Contents for DWS-1008
Page 1: ......
