802.11 b/g Access Point Command Line Interface Manual
9
5
W
IRELESS
C
OMMANDS
Fundamental
Config Commands:
Function
Syntax
config wlan
Select WLAN Adapter to configure. DWL-2100AP only WLAN 1 is
available for configuration. This command is not necessary.
config wlan [0:1]
Find Commands:
find bss
Perform Site Survey, Wireless service will be disrupted
find bss
find channel
Channel spanning to select the Preferred Channel
find channel
find rogue
Find Rogue BSS
find rogue
find all
Perform Site Survey including Super G and Turbo, Wireless service will
be disrupted
find all
Get Command:
Function
Syntax
get serviceType
Display Service Type
get serviceType
get apmode
Display current AP Mode
get apmode
get ssid
Display Service Set ID
get ssid
get ssidsuppress
Display SSID Suppress Mode is enabled or disabled
get ssidsuppress
get station
Display Client Station Connection Status
get station
get wdsap
Display WDS Access Point List
get wdsap
get remoteAp
Display Remote AP's Mac Address
get remoteAp
get association
Display Association Table that indicates the information of associated
client devices
get association
get autochannelselect
Display state of Auto Channel Selection feature (enabled, disabled)
get autochannelselect
get frequency
Display Radio Frequency (MHz)
get frequency
get channel
Display Radio Frequency (MHz) and Channel Designation
get channel
get availablechannel
Display available Radio channels
get availablechannel
get rate
Display current Data Rate selection. Default is best.
get rate
get beaconinterval
Display Beacon Interval
get beaconinterval
get dtim
Display Delivery Traffic Indication Message Beacon Rate
get dtim
get fragmentthreshold
Display Fragment Threshold in bytes
get fragmentationthreshold
get rtsthreshold
Display RTS/CTS Threshold
get rtsthreshold
get power
Display Transmit Power Setting: Full, half, quarter, eighth, min
get power
get targetPower
Display Target Power Setting
get targetPower
get controlPower
Display Control Power Setting
get controlPower
