DVG-G1402S User’s Manual
34
D-Link Systems, Inc.
Using the Configuration Utility (continued)
Using the Configuration Utility
Pass or Block:
Protocol:
IP Address Source:
IP Address Destination:
Subnet Mask Source:
Subnet Mask Destination:
Source Start/End Port:
Destination Start/End Port:
Enter the MAC address of the computer or device to allow
connectivity to the DVG-G1402S.
Advanced > Firewall
Select to enable or disable the rule.
Enter the IP address of the source computer.
Enter the IP address of the destination computer.
Enter the subnet mask of the source computer.
Enter the port range you want to open. If you want to open only
one port, enter the same port in both boxes.
Enter the subnet mask of the destination computer.
Enter the port range you want to open. In most cases, the source
and destination port(s) will be the same.
< :
specifies the port numbers less than and equal to the Start Port number
> :
specifies the port numbers greater than and equal to the Start Port number
= :
sets the port number equal to the Start Port if there is no End Port specified; if an End Port
number is specified, this defines a range of ports to filter. The range is defined as the port numbers
between the Start Port and End Port, including the Start and End Port numbers.
Summary of Contents for DVG-G1402S - Wireless Broadband VoIP Router
Page 1: ......