D-Link Systems, Inc.
7
DSM-G600 Install Guide
Installing the Hardware
Installing the Hardware (continued)
E.
Use the mounting screw to
secure the hard drive to the
DSM-G600. Replace the
cover and screw the two
screws on the back panel
of the DSM-G600.
D.
While facing the back of
the DSM-G600, insert
the right side of the hard
drive into the case. Once
in place, snap down the
left side.
F.
Connect an Ether net
cable to the Ethernet port
located on the back of the
DSM-G600.
Note:
It is required that an Ethernet cable is used during initial setup. Once
your wireless configuration is set, you may disconnect the Ethernet cable and
begin communicating wirelessly with your DSM-G600.
