D-Link DSL-500, User Manual

Page: 66 / 78

DSL-500 ADSL Router User’s Guide
72
HyperTerminal Interface (Boot Up)
To change the IP address of the Router type ip after the command prompt and hit Enter. Be sure to type
commands using all lower case letters as the console interface is case sensitive. A new command prompt
192.168.0.1 ip> will appear indicating that the unit is now ready to accept ip commands.
Type the following command series after the ip prompt:
enable ethernet
followed by the new IP address
to be assigned to the device as seen in the example below.
HyperTerminal Interface with new IP address
You must save the new IP address by typing the command series
config save
and pressing Enter. This will
save the new IP address for the Router and store it in the device’s flash memory. You may now disconnect the
terminal emulator and access the device using the web-based management interface for configuration. For more
thorough instructions on using the out-of-band console manager, see Chapter 7. FIND ALL REFS