OPERATION
~ 15 ~
?Pressing the ESC key exits the current screen.
?To view a different BANK, pressing the PAGE UP key goes to a previous BANK, while
the PAGE DOWN key brings you to the next BANK.
?Once you have selected a computer on the menu, press ENTER to switch to that port.
?Pressing the TAB key opens up the Function menu. In this menu, you can select the
SCAN TIME and DISPLAY TIME.
NOTE
: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are
set on the MASTER unit only, and need not be set on the slave units.
The Bank/SCAN Button:
Pressing the Bank/SCAN button cycles you through all the active BANKs (if there are
slave units present) and then puts the unit in AutoScan mode. If the unit is a single
MASTER unit, pressing the button immediately invokes AutoScan mode. This is evident
by a long beep, followed by two short beeps.
SCAN TIME:
Amount of time the DKVM-8 stays one port
before switching to the next port when in
Scan Mode
DISPLAY TIME:
Amount of time the OSD Menu or Port
Name remains displayed on-screen after
making a port selection
SCAN TIME:
DISPLAY TIME:
7se c
15sec
30sec
60sec
7sec
15sec
30sec
60sec
[ ]: SELECT
(INS): RENAME
(Enter): COMPLETE
(Esc): Exit
