5
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that
20 cm is maintained between the antenna and users,
and 2) The transmitter module may not be co-located with any other transmitter or
antenna. 3) For all products market in US, OEM has to limit the operation channels in CH1
to CH11 for 2.4G band by supplied firmware programming OEM shall not supply any tool or
info to the end-user regarding to Regulatory Domain change.
As long as
3
conditions above are met, further transmitter test will
not be required. However, the OEM integrator is still responsible for testing their
end-product for any additional compliance requirements required with this module
installed (for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE:
In the event that these conditions can not be met (for example
certain laptop configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not be used on the final
product. In these circumstances, the OEM integrator will be responsible for re-evaluating
the end product (including the transmitter) and obtaining a separate FCC authorization.
END PRODUCT LABELING
This transmitter module is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users (for
example: Access point, Wireless Router..etc.). The final end product must be labeled in a
visible area with the following: “Contains TX FCC ID: KA2DIR615A1”.
MANUAL INFORMATION THAT MUST BE INCLUDED
The
OEM integrator has to be aware not to provide information to the end user regarding
how to
install or remove this RF module in the user's manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this manual.
The users manual for OEM integrators must include the following information in a prominent
location “
IMPORTANT NOTE:
To comply with FCC RF exposure compliance requirements,
the antenna used for this transmitter must be installed to provide a separation distance of at least
20 cm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter. We declare that the product is limited in CH1~CH11 by specified
firmware controlled in the USA.
