D-Link DIR-450 Quick Install Guide
Connect to your Network
Note: Ensure that power to your DIR-450 Mobile Router is not connected before
performing the installation steps below.
32-bit PCMCIA (EVDO) Card Connection
1. Attach the antenna.
a. Remove the antenna from its plastic wrapper.
b. Screw the antenna in a clockwise direction to the back panel of the
unit.
c. Once secured, position the antenna upward at its connecting joint. This
will ensure optimal reception.
2. Insert your wireless 32-bit PCMCIA (EVDO) card into the Internet Card
Slot on the back of the router.
3. Insert the Ethernet cable into LAN Port 1 on the back panel of the DIR-450
Mobile Router, and an available Ethernet port on the network adapter in
the computer you will use to configure the unit.
Note: The DIR-450 Mobile Router LAN Ports are “Auto-MDI/MDIX.” This provides
either patch or crossover Ethernet cable LAN Port access.
4. Connect the power adapter to the receptor on the back panel of your
DIR-450 Mobile Router. Then plug the other end of the power adapter into
a wall outlet or power strip.
a. The Power LED will turn ON to indicate power has been applied.
b. Other LEDs will flash ON and OFF as the DIR-450 Mobile Router
performs initialization and Internet connection processes. This will take
a few minutes.
c. When complete, the following LEDs will illuminate blue: Power,
Status, Internet, WLAN, and LAN Port 1 (or your specific LAN Port
connection).
Summary of Contents for DIR-450 - 3G Mobile Router Wireless
Page 1: ......
