D-Link Co.,_______________________________________________________________________ FAQ
FAQ: 16
Currently, the only method available for backing up and restoring
the Router’s configuration is locally through the RS-232 port.
Menu 24.5 and 24.6 provide simple methods to perform the backup
and restoration.
11.
How do I enable DOVBS when I make an outcall?
You can enable DOVBS (Data Over Voice Barrier Service) can be
enabled in menu 11. When you configure your remote node to make
an outcall, set the ‘Telco Option: Transfer Rate’ field to
‘DOVBS’. If you check the system status menu (24.1) the
connection Type should be 56K.
The Router can automatically detect an incoming DOVBS call. Once
the call is connected, menu 24.1 will also indicate a Type of
56K.
12.
How I can prevent any packets from triggering a call?
For those customers that pay by the call, and not the minute,
they can set up a call filter to stop packets from triggering the
call. Set the destination IP address to 0.0.0.0 (filter ALL
packets). Also set the Idle Timeout of that remote node to zero.
To trigger the call in this scenario, use the option in menu
24.4.5 (manual call). This way, the call will never time out but
it will also never automatically dial either.
13.
How can I turn on call tracing tools?
For call setup EPA trace:
. Go to CI (Menu 24.8) issue ‘isdn ana on’ command
. make a call
. after the call failed (disconnected), issue ‘isdn ana off’
and
‘isdn ana disp’ (You have to do this in RS-232
connection,
and use the PgDn in number keypad to scroll the
trace)
For PPP trace:
. Go to CI, ‘sys trcl cl’ and then ‘sys trcl sw on’, ‘sys trcp
sw on’
. make a call
. ‘sys trcl disp’ to display the traces
14.
How can I configure the correct default static route for my
Router?
You can do this by configuring an IP static route in menu 12.
The Destination IP Address for this route should be ‘0.0.0.0’.
Once this has been configured, the default route should be stored
correctly.
15.
How do I setup the Router to make MP calls?
By default, the Router is set to only make single link calls
(using 1 B-channel). You can configure your Router to make an MP
call by setting some parameters for that Remote Node. When you
