D-Link DGE-560T User Manual
0
Troubleshooting
Confirming.the.Connection.(LED.Indicator)
When the computer is powered “ON” and the D-Link DGE-560T is inserted into an open PCI Express slot, please check the following items
if your LED light is not “ON”. When all items are working, your D-Link DGE-560T’s ACT/Link LED light should light up green (“linkage”
state).
1. Make sure that your Ethernet CAT5 cable is in good working order.
2. Make sure that your hub or switch is powered “ON” and is functioning properly.
3. If the LED remains dark without any apparent cause, check the “Device Manager”. If there is an exclamation point
next to the D-Link DGE-560T, then double-click to open. A message indicating the error will appear.
4. After verifying that the D-Link DGE-560T has been installed correctly, check steps 1 and 2 again. If you continue to
encounter a problem, please call D-Link Technical Support for assistance.
Troubleshooting.the.Hardware.Installation
If you experience any problems with the hardware installation, first ascertain that all network cable connections are firm, that the proper
grade of cable is used for the network connection, and that the cable makeup is correct (straight without un-needed crossovers in the
connector wiring). Check that the supporting hub is powered-on and operating normally, and that the hub is properly qualified (under
100Base-TX and/or 1000Base-T standards).
Summary of Contents for DGE-560T - Gigabit PCI-Express SNMP VLAN Flow Control Network Adapter
Page 1: ......
Page 30: ...D Link DGE 560T User Manual 27 4 Click Next 5 Click Install ...
