![background image](http://html1.mh-extra.com/html/d-link/dcs-3430/dcs-3430_user-manual_3204543048.webp)
48
D-Link DCS-3411/3430 User Manual
Section 3 - Configuration
RS-485
Support PAN-TILT:
Protocol:
ID:
Baud Rate:
Data Bit:
Stop Bit:
Parity Bit:
When enabling Support PAN-TILT, a control panel will be displayed
on the Live Video page allowing control through RS-485 for an
external camera enclosure.
Select one protocol type from the pull-down menu.
Range from
1
to
255
, is the identifier for each RS-485 devices.
Range from
2400
to
38400
bps. It is a speed measurement for
communication between a transmitter and receiver, indicates the
number of bit transfers per second. Higher baud rate will reduce
the distance of the two devices (transmitter and receiver). By
default, the value is
2400
.
Either
7
or
8
. It is a measurement of the actual data bits in a
transmission. By default, the value is
8
.
Either
1
or
2
. It is used to signal the end of communication for a
single packet. The more bits used for stop bits, the greater the
lenience in synchronizing the different clocks but the slower the
data transmission rate. Bye default, the value is
1
.
Choices of
No
,
Even
, and
Odd
. It is a simple form of error checking
used in serial communication and you may use no parity. For even
and odd parity, the serial port sets the parity bit (the last bit after
the data bits) to a value to ensure that the transmission has an
even or odd number of logic-high bits.
For example, if the data is 011, for even parity, the parity bit is 0
to keep the number of logic-high bits even. If the parity is odd,
the parity bit is 1, resulting in 3 logic-high bits.
You may configure the
RS-485
settings or communication specifications (baud rate, data bit, stop bit, and parity bit) for your
camera. RS-485 is a serial communication method for computers and devices. For your camera, RS-485 is used to control a
PAN/TILT device, such as an external camera enclosure to perform PAN and TILT movement.