3
D-Link DCS-3110 Quick Install Guide
Hardware Overview
Hardware Overview
Connections
Rear View
Audio Out Connector:
Use the Audio Out connector for
2-way audio connection. Speakers
(not included) may be connected
to the camera for 2-way audio
communication.
Reset Button
Reset is initiated
when the reset button
is pressed once and
held 30 seconds
until the power LED
flashes through its
cycle twice.
Power Receptor
Receptor for the
supplied power
adapter.
DI/DO:
The DCS-3110 provides a general I/O terminal block. The I/O
connectors provide the physical interface to send and receive
digital signals to and from a variety of external devices.
DC12V output :
Support for external device (like IR light)
RS485:
Port is designed for external pan/tilt/zoom devices.
Ethernet Port (PoE)
Connect the Network Camera to your network
using a CAT5 Ethernet cable. This port
supports the NWay protocol, allowing the
network camera to automatically detect or
negotiate the transmission speed of the
network.
The Ethernet port can also be used to power
the camera by using a PoE switch.
Status LED
Blinking Red:
indicates power is
being supplied to the camera.
Solid Green:
indicates that a
connection has been established
via Ethernet port.
Blinking Green:
indicates traffic
movement in the camera.
If the Ethernet connection is not
established the Status LED will
not glow.
Mic On/Off Switch:
Select to turn the
microphone On or Off.
Microphone Connector:
The
camera has an internal built-in
microphone. To use an external
microphone, plug it into the
microphone connector.