2
D-Link Nuclias Cloud Router
E
NG
LIS
H
About This Guide
This guide gives step by step instructions for
setting up D-Link DBG-2000. Please note that the
model you have purchased may appear slightly
different from those shown in the illustrations.
Item Feature
Description
A
LED
(Top to bottom)
Power LED: Indicates the device is
powered on.
B
Ethernet ports
(1-4)
Connect Ethernet devices, such as
computers, switches and hubs.
C
Gigabit WAN
port (2)
Two auto MDI/MDIX WAN ports
are the connection for the Ethernet
cable to the cable or DSL modem.
D
Console Port (1)
Used to access Command Line
Interface (CLI) via RJ45-to-DB9
console Cable.
Table 1: DBG-2000 Front Panel Descriptions
Device Status LEDs and Ethernet Port LEDs
The device LEDs show information about current
device status. When the device power up, the
POWER/STATUS LED will show solid orange
during power on process. Startup takes one minute
approximately to complete, the LED will change
to solid green. If you want to turn the device off
and on again, we recommend you wait a few
seconds between shutting it down and powering it
back. The Ethernet LEDs show the status of each
Ethernet port. Table 2 lists the name, color, status
and description of each device LED.
Figure 2. Ethernet RJ-45 Port LEDs
TX/RX
Status
Link
Speed
Unpacking the Product
Open the shipping carton and carefully unpack its
contents. Please consult the packing list located
in following information to make sure all items are
present and undamaged. If any item is missing
or damaged, please contact your local D-Link
reseller for replacement.
- One (1) DBG-2000 One (1) 12V/2A Power
Adapter
- One (1) Console Cable (RJ45-to-DB9 Cable)
- One (1) Ethernet (CAT5 UTP/Straight Through)
Cable
- Four (4) Rubber foot
Product Overview
This chapter provides detailed descriptions of the
DBG-2000 device and its components.
LED
Indicative
Color
Status
Description
Power
Orange/
Green
Solid Orange
Device during power-on
process
Solid Green
Completion of power on
Light Off
The device is power-off
Cloud
Green/
Orange/
Red
Solid Orange
Device is connecting to Cloud
Solid Green
Device is in Cloud mode
Solid Red
Device is not in Cloud mode
Blinking
Orange
Device is upgrading firmware
or resetting factory default
LAN
RJ45
Phone
Jack
Green/
Amber
Right Side
Solid Amber
10/100Mbps Link Present
Blinking
Amber
There is activity on this port
Light Off
No link
Left Side
Solid Green
1000Mbps Link Present
Blinking Green There is activity on this port
Light off
No Link
WAN
RJ45
Phone
Jack
Blue/
Green/
Amber
Right Side
Solid Green
1000Mbps Link Present
Solid Amber
10/100Mbps Link Present
Blinking
Green/Amber
There is activity on this port
Light Off
No link
Left Side
Solid Blue
2.5Gbps Line Present
Blinking Blue
There is activity on this port
Light Off
No link
Table 2: Device Status LED Descriptions
Front Panel
Figure 1. DBG-2000 Front Panel
A
B
C
D E
E
USB Port (1)
It can support various USB 2.0, 3.0
devices below:
1.Flash Disk or Hard Disk for
network sharing.
2.Printer (It will be supported by
future firmware upgrade)
