Quick Installation Guide
5
ENGLISH
Figure 9: Using the Setup Wizard
Configuring the Second DAP-3712
in Client Mode
1.
Follow steps 1-4 of the instructions above
to power on the device. Launch the Setup
Wizard to configure the device in Client
Mode.
2 .
T o avoid an IP address conflict, change
the IPv4 address so that it is different
from the first DAP-3712's IP address (for
instance, by changing it to
192.168.0.51
,
as in the following screenshot).
Figure 10: Changing the IP Address
3.
On step four of the Setup Wizard
(
Wireless
), select
Client
from the drop-
down list. Enter the same SSID and key
that you entered when configuring the
first device.
Figure 11: Configuring Client Mode
4.
To confirm that wireless connectivity
between the two devices is configured
correctly, navigate to the
Status
page and
check the information under
Associated
Stations
(shown below).
Figure 12: Checking Wireless Connectivity
Mounting the Device
Installation Recommendations
If you plan to install the DAP-3712 on a pole,
orient the front of the access point toward the
intended coverage area. The radio antenna
transmits through the front of the access point
but not through the reverse side (where the
bracket is).