D-Link DAP-3220, Reference Manual, Page: 12 / 35

802.11 b/g Access Point Command Line Interface Manual
10
get availablechannel Display available Radio channels get availablechannel
get rate Display current Data Rate selection. Default is best. get rate
get beaconinterval Display Beacon Interval get beaconinterval
get dtim Display Delivery Traffic Indication Message Beacon Rate get dtim
get fragmentthreshold Display Fragment Threshold in bytes get fragmentationthreshold
get rtsthreshold Display RTS/CTS Threshold get rtsthreshold
get power Display Transmit Power Setting: Full, half, quarter, eighth, min get power
get targetPower Display Target Power Setting get targetPower
get controlPower Display Control Power Setting get controlPower
get swPower Display Software Power Setting get swPower
get SuperG Display SuperG Feature Status of enabled or disabled get SuperG
get wlanstate Display Wireless LAN state status (enabled or disabled) get wlanstate
get shortpreamble Display Short Preamble Usage state: enabled or disabled get shortpreamble
get wirelessmode Display Wireless LAN Mode (11b or 11g) get wirelessmode
get 11gonly Display 11g Only Mode operational state of enabled or disabled get 11gonly
get antenna Display Antenna Diversity of 1, 2, or best get antenna
get sta2sta Display wireless STAs to wireless STAs connect state get sta2sta
get eth2sta Display ethernet to wireless STAs connect state get eth2sta
get eth2wlan Display Eth2Wlan Broadcast packet filter state get eth2wlan
get macaddress Display Mac Address get macaddress
get config Display Current AP Configuration Settings get config
get countrycode Display Country Code setting get countrycode
get hardware Display Hardware Revisions of WLAN Components get hardware
get diap Display DIAP State get diap
get aging Display Aging Interval in seconds get aging
get ratecontrol Display supported data rate state get ratecontrol
get supportrate Display supported data rate get supportrate
Set Command: Function Syntax
set apmode
Set AP Mode to Normal AP, Point to Point Bridge, Point to Multipoint
Bridge.
set apmode [ap:p2p:p2mp:p2pwithoutap: p2mpwithoutap]
set ssid Set Service Set ID
set ssid <SSID>
SSID should be less than 33 strings.
set ssidsuppress Set SSID Suppress Mode enable or disable set ssidsuppress [disable: enable]
set autochannelselect Set Auto Channel Selection to enable or disable set autochannelselect [disable:enable]
set frequency Set Radio Frequency (MHz) set frequency <24xx>
set rate Set Data Rate set rate [best:1:2:5.5:6:9:11:12:18:24:36:48:54]