35
v
Double-click
on
Network
Adapters
v
Right-click
on
D-Link
Air
Pro DWL-A650
Wireless Cardbus
Adapter
v
Select
Properties
to
check that the drivers are
installed properly
Check that the
Ethernet LED
on the DWL-G700AP is
ON
. If the
LED
is not
ON
, check that the cable for the Ethernet connection is securely
inserted.
Check that the Ethernet adapter is working properly. Please see item
3 (
Check that the drivers for the network adapters are installed
properly
) in this
Troubleshooting
section to check that the drivers
are loaded properly.
Check that the
IP address
is in the same range and subnet as the
DWL-G700AP. Please see
Checking the IP Address
in Windows XP
in the
Networking Basics
section of this manual.
Do a
Ping test
to make sure that the DWL-G700AP is responding. Go
to
Start
>
Run
>Type
Command
>Type
ping 192.168.0.50.
A successful
ping will show four replies.
Note: It is recommended that you use an Ethernet connection to configure the
DWL-G700AP Access Point.
1. The computer used to configure the DWL-G700AP cannot access the
configuration menu.
Note: The IP address of the DWL-G700AP is 192.168.0.50. All the computers on
the network must have a unique IP address in the same range, e.g., 192.168.0.x.
Any computers that have identical IP addresses will not be visible on the network.
They must all have the same subnet mask, e.g., 255.255.255.0
Troubleshooting
This chapter provides solutions to problems that can occur during the installation and
operation of the DWL-G700AP. We cover various aspects of the network including
network adapters.
(The examples below are illustrated in Windows XP. If you have
another operating system, these solutions will still apply, although the appearance on
your computer screen may differ.)
