802.11 a/b/g Access Point Command Line Interface Manual
10
get 11gonly
Display 11g Only Mode operational state of enabled or disabled
get 11gonly
get antenna
Display Antenna Diversity of 1, 2, or best
get antenna
get sta2sta
Display wireless STAs to wireless STAs connect state
get sta2sta
get eth2sta
Display ethernet to wireless STAs connect state
get eth2sta
get trapsevers
Get trap server state
get trapsevers
get eth2wlan
Display Eth2Wlan Broadcast packet filter state
get eth2wlan
get macaddress
Display Mac Address
get macaddress
get config
Display Current AP Configuration Settings
get config
get countrycode
Display Country Code setting
get countrycode
get hardware
Display Hardware Revisions of WLAN Components
get hardware
get aging
Display Aging Interval in seconds
get aging
get MulticastPacketControl
Display Multicast Packet Control state get
MulticastPacketControl
get
MaxMulticastPacketNumber
Display Max Multicast Packet Number get
MaxMulticastPacketNumber
get 11goptimize
Display 11g Optimization Level
get 11goptimize
get 11goverlapbss
Display Overlapping BSS Protection
get 11goverlapbss
get assocnum
Display Number Of Association STA
get assocnum
get eth2wlanfilter
Display Eth2WLAN BC & MC filter type
get eth2wlanfilter
get extendedchanmode
Display Extended Channel Mode
get extendedchanmode
get iapp
Display IAPP State
get iapp
get iapplist
Display IAPP Group List
get iapplist
get iappuser
Display IAPP User Limit Number
get iappuser
get minimumrate
Display Minimum Rate
get minimumrate
get dfsinforshow
Display DFS infor
get dfsinforshow
get wdsrssi
Display WDS Access Point RSSI
get wdsrssi
get ackmode
Display Variable Ack Time Mode
get ackmode
get acktimeout
Display Ack Time Out Number
get acktimeout
Set Command:
Function
Syntax
set apmode
Set AP Mode to Normal AP, WDS with AP Mode,WDS without AP Mode
or AP Client
set apmode [ap:wdswithap:wds:apc]
set ssid
Set Service Set ID
set ssid <SSID>
set ssidsuppress
Set SSID Suppress Mode enable or disable
set ssidsuppress [disable:enable]
set autochannelselect
Set Auto Channel Selection to enable or disable
set autochannelselect [disable:enable]
set rate
Set Data Rate
set rate [best:1:2:5.5:6:9:11:12:18:24:36:48:54]
set beaconinterval
Modify Beacon Interval 20-1000
set beaconinterval [20-1000]
