USB Configuration Utility
When the Wireless AP
USB Configuration
Utility and Wireless AP
SNMP
(
S
imple
N
etwork
M
anagement
P
rotocol)
Utility
have been installed you can
configure settings for the access point. Before you can use the SNMP Utility,
you must configure the device IP address. The IP address of the device must
be on the same subnet and use the same subnet mask as the computer
using the SNMP Utility.
Using the USB Configuration Utility
To use the USB Configuration Utility and change the IP settings of the
Access Point, follow these steps:
1. To launch the USB Configuration Utility, go to your
Start
menu, open
Programs
, find the
Wireless AP
folder and open it. You will see two new
icons have been placed in this folder. Scroll to the
Wireless AP USB
Utility
and click on it to launch the program.
2. The
Admin Password
screen will ask you for a password. The default
password is “public” (all lower case), type this in the space and click
OK
.
3. The
USB Configuration Utility
management interface will appear
displaying system information about the Wireless Access Point. To
access any of the menus listed just click on the tab. If you intend to use
the SNMP Utility to manage and configure the device you must first
change the IP settings.
4. Click the
IP Config
tab to change the IP settings of the device.
