D Light Aura, User Manual

Page: 10 / 53

16
- GB GB -
17
ENGLISH ENGLISH
NOTE:
If large stains appear inside the treatment surface (12) or if the latter is cracked or broken, do not
use the appliance and contact the D Light Service center. After replacing the lamp, always set the
energy level to lower than the one used normally. In the next session, increase the energy level
again only if the there is no abnormal discomfort during or after treatment.
PROBLEMS AND SOLUTIONS
PROBLEM CONTROL/SOLUTION
The appliance does not start
Connect to a better power socket
Contact our customer support
The contact sensor does not detect the skin
Replace the lamp
Contact our customer support
The appliance does not emit pulses
Check if the display does not blink when in
contact with the skin
Replace the lamp
Contact our customer support
The device buttons are not pressure sensitive Contact our customer support
The status displays the message “error”
Disconnect and reinsert the light
Replace the lamp
Contact our customer support
TECHNICAL SPECIFICATIONS
Type of Light HR
Wavelength HR 510nm~1200nm
Area spot 4.5 cm²
Energy density 4.7 ~ 6.7 J/cm²
Pulse number 400.000
Energy level 1 ~ 5
Power supply AC100V-240V,50Hz/60Hz
Rated input power 36W
Net weight 280g
Equipment size L176 x W74 x H46mm
ENVIRONMENTAL SPECIFICATIONS
Operating Ambient Temperature: 10ºC ~ 30ºC
Storage Ambient Temperature: -10ºC ~ 55ºC
Degree of Operation Humidity: up to 80% at 37ºC
Degree of Moisture Storage: up to 90% at 55ºC
Atmospheric Operation Pressure: 700-1060 hPa
Maximum operating altitude: up to 3900 mt.
Do not expose device directly to the sun or other radiation
Never immerse the appliance or any of its parts in water!