5
Accuracy Micro Adjustment (2)
When a 46 or 47 degree is needed,
two screws in the front of the head as
shown can be adjusted.
Note: when adjusting the screws, the
turning amount between these two
screws must be same in order to keep
the cutting accuracy and the balance.
Accuracy Micro Adjustment (1)
In case the cutting accuracy is off set, two
screws under the working table can be
adjusted in either direction as shown. Also
these two screws are used to obtain minus
2 degree if needed.
Note: when adjusting the screws, the
turning amount between these two screws
must be same in order to keep the cutting
accuracy and the balance.
Angle Cutting
Change the angle attachment to the
desired angle and place the work-piece
along the attachment. Press down the
handle to complete the cut.
Summary of Contents for TC-100
Page 1: ...OPERATION MANUAL Trim Cutter TC 100 www dcutproducts com...
Page 7: ...7 Part List...
Page 9: ...9...
