4
Mitre Cut (3)
The work-piece must stop at/against
the nylon board as shown before
making a mitre cut, to ensure an
accurate angle cut.
Warning:
A
lways making a square (vertical) cut
BEFORE
making a mitre cut.
The blade
damage may occur if making a mitre
cut on the work-piece directly.
Mitre Cut (2)
There are two slots on the handle base as
shown. One of them is for vertical cut and
another is for angle cut. Push the handle to
right in order to change the position as
shown.
Mitre Cut (1)
Change the cutting head to the desired
angle as shown.
Summary of Contents for TC-100
Page 1: ...OPERATION MANUAL Trim Cutter TC 100 www dcutproducts com...
Page 7: ...7 Part List...
Page 9: ...9...
