4
“L” Cut
When making an “L” cut, it is
recommended to cut the lengthwise
first, following the “Lengthwise Cutting”
procedure to cut plank to the required
point and then re-position the plank,
make a last cut “cut-out”.
Lengthwise Cut
When cutting laminate lengthwise, remove
the stopper from the cutter base. Mark a
line on the laminate plank and place it on
the base. Hold it down firmly while
pushing down the cutter blade. Small teeth
located along the cutting slot will keep the
laminate plank from slipping.
After making each cut pull the handle back
up, the small pin featured on the blade
helps to move the plank forward. Use your
hand to push down the plank and then cut
again. Repeat the procedure until the full
length of the cut is completed.
Free Angle Cut
Mark a line of the floor plank and remove
the stopper attachment from the cutter
base. Line up the blade with the line
marked on the plank, then push down the
blade by using the handle. The small teeth
located along the cutting slot will keep the
laminate plank from slipping.
After making each cut pull the handle back
up, the small pin featured on the blade
helps to move the plank forward. Use your
hand to push down the plank and then cut
again. Repeat the procedure until the full
length of the cut is completed.
